Hang-TITE Installation Tool
Roll over image to zoom in
Hang-TITE™ Rod Hanger Screw
Installation Tool
The product is only intended to be used with:
Hang-TITE™ Rod Hanger Screw - Concrete applications
Downloads / Tech Flyer
Materials / Finishes
- Zinc-plated Carbon Steel
Features and Benefits
- One-pieces screw design: threaded portion of the screw will not prematurely break away from the screw head
- Available in various thread types for concrete, wood or steel
- Horizontal (side) mount available for both steel and wood Hang-TITE screws
- Rapid installation: all Hang-TITE screws can be installed using a screw gun or drill
Installation
Part Numbers
Catalog Number
Description/Size
Box Quantity
Carton Quantity
HTWSST
Universal Steel & Wood Socket
1
10
HTCST14
1/4 Concrete Socket
1
10
HTCST38
3/8 Concrete Socket
1
10
HTCST12
1/2 Concrete Socket
1
10
Wood
- Mount the Universal Steel & Wood Socket Drive (Part No. HTWSST) into the chuck of the drill.
NOTE: Certain types of wood truss/wood joint require pre-drilling with a 1/8” diameter bit - Insert the head of the anchor into the socket driver.
- Press the tip of the anchor against the wood surface [or press tip into pre-drilled hole, if needed].
- Install with a smooth, steady motion until the anchor is firmly seated against the wood.
- Thread the appropriate diameter steel threaded rod or threaded bolt into the anchor. The threaded rod or bolt should fully engage the thread length of the anchor.
Steel
- Mount the Universal Steel & Wood Socket Drive (Part No. HTWSST) into the chuck of the drill.
- Insert the head of the anchor into the socket driver.
- Press the tip of the anchor against the steel surface and install with a smooth, steady motion until the anchor is firmly seated against the steel. No pre-drilling is required.
- Add the retainer nut [if needed].
- Thread the appropriate diameter steel threaded rod or threaded bolt into the anchor. The threaded rod or bolt should fully engage the thread length of the anchor.
Concrete
- Use the correct size masonry drill and drill the hole at least one anchor diameter deeper than the calculated embedment depth. Clean the hole using a nylon brush and compressed air.
- Select the appropriate size socket driver (Part No. HTCST14, HTCST38 or HTCST12) and mount it into the chuck of the drill.
- Insert the head of the anchor into the socket driver.
- Press tip into pre-drilled hole and install with a smooth, steady motion until the anchor is firmly seated against the concrete.
- Thread the appropriate diameter steel threaded rod or threaded bolt into the anchor. The threaded rod or bolt should fully engage the thread length of the anchor.
